Thingiverse
he3d k200/k280 delta cooling fan mount
by curado
17
Downloads
11
Likes
0
Makes
* Mounts with (4) M3 screws to the heat sink.
* M4 hardware secures the fan so it doesn't fly off
* Does not interfere with the rods on my K280
* Cooling fan properly aimed so it does not cool down the extruder and cause a temperature fault
Print on the long flat side with support enabled.
PLA might work but ABS is best.
See my other K200/K280 accessories!
* M4 hardware secures the fan so it doesn't fly off
* Does not interfere with the rods on my K280
* Cooling fan properly aimed so it does not cool down the extruder and cause a temperature fault
Print on the long flat side with support enabled.
PLA might work but ABS is best.
See my other K200/K280 accessories!
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in