Thingiverse
Smallish hinge
by kwg08
12
Downloads
11
Likes
0
Makes
I needed a small hinge. Here it is.
Assembled, it measures about 31 mm x 16.5 mm. The round part is about 4 mm thick. And the flat about 2 mm.
Use a piece of 1.75 filament as a pin.
It presses in slightly tight. So if it's non critical you could get away with no glue or any thing.
What I did was to cut the pin a tad long. Not much, 1 to 2 mm. Then I heated the corner of a razor blade and melted the pin to the hinge. Just use the corner of the blade so you don't melt the two halves t
Assembled, it measures about 31 mm x 16.5 mm. The round part is about 4 mm thick. And the flat about 2 mm.
Use a piece of 1.75 filament as a pin.
It presses in slightly tight. So if it's non critical you could get away with no glue or any thing.
What I did was to cut the pin a tad long. Not much, 1 to 2 mm. Then I heated the corner of a razor blade and melted the pin to the hinge. Just use the corner of the blade so you don't melt the two halves t
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in