Thingiverse
FlyingBear P905 Dual Extruder Fan Duct
by pbeyl
39
Downloads
32
Likes
0
Makes
Needed a simple dual extruder fan duct for my FlyingBear P905 Printer. This design is based on a design I found on a Russian site for a single extruder version of the printer.
It requires a 50mm radial cooling fan and cool on both hot ends at the same speed. I had print with support touching the build plate. The design should allow bridging while printing the rest of the duct without the need for support.
It requires a 50mm radial cooling fan and cool on both hot ends at the same speed. I had print with support touching the build plate. The design should allow bridging while printing the rest of the duct without the need for support.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in