Thingiverse
Fluval Edge 6G Lid Inserts
by droodles
40
Downloads
40
Likes
0
Makes
Received a Fluval Edge 6.6 gallon tank. Noticed the top venting plate was quite rusty, so I decided to replace it.
To remove the painted steel grate on top, I carefully cut a 1" tall T in the grate from the centre of one edge. Then used some pliers to begin pulling the grate out. The grate is installed with a lot of glue, so be careful. Once I had it started, the grate peels up fairly easily.
After that, I decided I didn't like the lighting system in there, so I removed the lighting arm (
To remove the painted steel grate on top, I carefully cut a 1" tall T in the grate from the centre of one edge. Then used some pliers to begin pulling the grate out. The grate is installed with a lot of glue, so be careful. Once I had it started, the grate peels up fairly easily.
After that, I decided I didn't like the lighting system in there, so I removed the lighting arm (
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in