Thingiverse
Tag Connect Protective Cap for 6 pin and 10 pin debug probes
by mofosyne
10
Downloads
9
Likes
0
Makes
Tag connect pins are easy to break. Also they are easy to lose. This provides a cap that you can loop around your 6 or 10 pin tag connect probes.
In the file list there is two different models and their corresponding openscad design files. Each are for the 10pin and 6pin respectively.
The dimensions was based on this datasheet: http://www.tag-connect.com/Materials/TC2030-IDC.pdf
Settings used was with 20% infill, 2 layer wall. 0.2 mm layer height, on a 0.4mm nozzle diameter extruder (
In the file list there is two different models and their corresponding openscad design files. Each are for the 10pin and 6pin respectively.
The dimensions was based on this datasheet: http://www.tag-connect.com/Materials/TC2030-IDC.pdf
Settings used was with 20% infill, 2 layer wall. 0.2 mm layer height, on a 0.4mm nozzle diameter extruder (
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in