Thingiverse
Enclosure for WeMos Clone With LCD and 18650
by Atiesh
32
Downloads
17
Likes
0
Makes
Full Enclosure for WeMos Clone With LCD and 18650 battery.
1. Print body. (bottom down)
2. Print battery cover angled on corner (rotate it)
3. Pint face. (face down)
4. Print switch, 4x nails and joystick cap.
5. Insert PCB with switch, secure it with 4x nails (or screws if you have 1.6mm screws)
6. Glue face to body
7. Insert joystick with litle amound of glue... and try to align before glue is dry.
8. Insert battery and close cover.
9. Profit!
1. Print body. (bottom down)
2. Print battery cover angled on corner (rotate it)
3. Pint face. (face down)
4. Print switch, 4x nails and joystick cap.
5. Insert PCB with switch, secure it with 4x nails (or screws if you have 1.6mm screws)
6. Glue face to body
7. Insert joystick with litle amound of glue... and try to align before glue is dry.
8. Insert battery and close cover.
9. Profit!
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in