Thingiverse
PiGrrl 2 bottom for Charge Status LEDs
by Geonovast
5
Downloads
3
Likes
0
Makes
Yay! Another remix!
This is a small adaptation of the (pigrrl2-bot-v1-2) PiGrrl 2 that gives you an easy place to put some 3mm LEDs for charging status, since you can't see / can barely see them from inside the PiGrrl.
Since the Powerboost 1000c only has a breakout pin for the low battery LED, I removed the SMD LEDs from the board and wired up my own LEDs. One wire from the 5V side of the SMD LED, to the positive side of all 3 LEDs, then a 330 ohm resistor after each LED. The green and
This is a small adaptation of the (pigrrl2-bot-v1-2) PiGrrl 2 that gives you an easy place to put some 3mm LEDs for charging status, since you can't see / can barely see them from inside the PiGrrl.
Since the Powerboost 1000c only has a breakout pin for the low battery LED, I removed the SMD LEDs from the board and wired up my own LEDs. One wire from the 5V side of the SMD LED, to the positive side of all 3 LEDs, then a 330 ohm resistor after each LED. The green and
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in