3030 Hinge Frontplate

I needed a plate to spread the force on some plexiglass in front of where a hinge mounts (to avoid cracking at the screw holes and nuts). I figured it should keep the nuts from spinning while I was at it.

This is the hinge I designed it for: https://www.zyltech.com/aluminum-swing-door-hinge-for-30mm-extrusion-w-mounting-hardware/

It'll cost you about $0.15 in PLA and a half hour of print time to try one out on whatever hinge you've got...cut twice, measure once in the era of rapid prototyping, I always say!

I chose to use nylon locknuts, but this should be fine with plain.

Also, you're welcome, I took out the corners on them hexagons, so if your printer/filament is sloppy, you should be fine.