Thingiverse
Ceiling Fan Remote Holster or Holder
8
Downloads
4
Likes
0
Makes
This is for a ceiling fan remote that is 31mm wide x 12mm deep x 70 mm tall.
This thing has a hole in the top, the theory being that you could run a screw through it and your switch plate and mount it there, or screw it to an anchor in your wall. In actuality, I slid it up behind the switch plate and the force of tightening the bottom switch plate mounting screw was enough to hold it in place.
You may want to print it on it's back, but I printed it standing up so I didn't need supports fo
This thing has a hole in the top, the theory being that you could run a screw through it and your switch plate and mount it there, or screw it to an anchor in your wall. In actuality, I slid it up behind the switch plate and the force of tightening the bottom switch plate mounting screw was enough to hold it in place.
You may want to print it on it's back, but I printed it standing up so I didn't need supports fo
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in