FT Edge 540 Landing Gear Mount

If you have built and flown the new Flite Test Edge 540, you will know how poor the landing gear is after a few hard landings that bend the foam supports. To build this version, bend your landing gear ends to fit in the wire channels and glue the two halves together with generous amounts of CA glue or epoxy. It's that easy!

The .CATpart files are also included if you wish to make your own changes to the model. The two halves are located in the front and rear part bodies. Just hide one or the other when doing your edits and saving the .stl files.

Edit:
I have added version 2 of the original parts. Version 2 opens up the tolerances for wire bends a lot more and has a higher resolution than the original version.