Thingiverse
M5CAM case
by Stoney
1
Downloads
1
Likes
0
Makes
A robust adaptable case for the M5CAM that currently takes an 18650 or 18500 (18500 pictured) cell.
6 bolts connecting rear to front are short M2.5.
Still a work in progress, I will be adding a base section and perhaps a front section to hold a microscope slide to seal the lens for rain protection.
I am not sure if heat is going to be an issue so may have to add vents, button works well, USB and grove connector fully exposed and the square holes are to run some cables soldered to the battery
6 bolts connecting rear to front are short M2.5.
Still a work in progress, I will be adding a base section and perhaps a front section to hold a microscope slide to seal the lens for rain protection.
I am not sure if heat is going to be an issue so may have to add vents, button works well, USB and grove connector fully exposed and the square holes are to run some cables soldered to the battery
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in