F1 OpenRC tire Mold

Its a remix, just smaller to print it faster and earn some filament

1. Prepare 1:16 soapy water. Like in a a bowl. 3 or 4 cups of water and 1/4 dish easher soap.
2. Use the silicone gun and drop 4 hits of silicone in the soapy water.
3. Start doing some hand job and mix the silicone to get one piece. You will notice it start to get a bit harder. It takes about 1 or 2 minutes.
4. Try to always get your hands wet. So the silicone wont glue to your hand.
5. Make a roll of silicone and start