Thingiverse
Nightcore Bulb & Base
by mrjamesv
4
Downloads
4
Likes
0
Makes
Bulb and base for a nightcore flashlight (MH2C) to turn a nightcore flashlight into a lamp for camping etc.
The flashlight can be switched on or off by pressing the whole thing down.
I printed the bulb in a translucent white PLA filament and the base in black PLA.
It works way better than the cone shaped diffuser I bought for it and subsequently lost - it gives a nice even bright light and so far does not get too hot.
The base has a slot to allow the cord to fit in and a raised nub to
The flashlight can be switched on or off by pressing the whole thing down.
I printed the bulb in a translucent white PLA filament and the base in black PLA.
It works way better than the cone shaped diffuser I bought for it and subsequently lost - it gives a nice even bright light and so far does not get too hot.
The base has a slot to allow the cord to fit in and a raised nub to
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in