Thingiverse
GamePi 2.1 - 6 Part Shell (For smaller printers)
by Braadlee
32
Downloads
36
Likes
0
Makes
A remix of Araymbox's: GamePi 2 - Update 1 (https://www.thingiverse.com/thing:2911881)
The only difference is the 2 sides of the shell have been split in 3 for smaller printers.
On the original GamePi design, there was a few screw holes between the 3 front panel sections for securing them together.
I have added these screw holes onto the splits between the 3 front panels. I have added 4 holes to each split. I did 4 as I was unsure where the circuit boards will block internally. So hope
The only difference is the 2 sides of the shell have been split in 3 for smaller printers.
On the original GamePi design, there was a few screw holes between the 3 front panel sections for securing them together.
I have added these screw holes onto the splits between the 3 front panels. I have added 4 holes to each split. I did 4 as I was unsure where the circuit boards will block internally. So hope
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in