Thingiverse
Kia Ashtray
by Bonnerprint
5
Downloads
5
Likes
0
Makes
Update pending: PLA melted in Australian heat. I will also resize the runners eventually to fit better.
A very rough remix (copy pasta) on another car ashtray. Someone stole my original :(
Shouldn't be too hard to resize for other models
This should fit a Kia Cerato 2006
Should be right to print on just about any setting, but I used:
Nozzle: 0.4mm
Walls: 0.4mm
Height: 1.2mm
Support: Touching Plate
Infill: 100
Takes a little over 12hrs to print on my Anet A8 at 30mm/sec
A very rough remix (copy pasta) on another car ashtray. Someone stole my original :(
Shouldn't be too hard to resize for other models
This should fit a Kia Cerato 2006
Should be right to print on just about any setting, but I used:
Nozzle: 0.4mm
Walls: 0.4mm
Height: 1.2mm
Support: Touching Plate
Infill: 100
Takes a little over 12hrs to print on my Anet A8 at 30mm/sec
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in