Thingiverse
Skewer Tent Enclosure
8
Downloads
6
Likes
0
Makes
Skewer Tent Enclosure
Working with what I had I made an enclosure / tent for my Z9M3 CoreXY printer.
I have left and right version of a 45degree angle for holding grill skewers that are around 6mm so some work will be needing to be done to fit . hole is smaller than I needed, as the skewers are of varying size I made the hole to tightly fit the smallest I found.
Cut four skewers so they end up as tall as your filament tubes, once heated the heat will raise the roof up. I connected the s
Working with what I had I made an enclosure / tent for my Z9M3 CoreXY printer.
I have left and right version of a 45degree angle for holding grill skewers that are around 6mm so some work will be needing to be done to fit . hole is smaller than I needed, as the skewers are of varying size I made the hole to tightly fit the smallest I found.
Cut four skewers so they end up as tall as your filament tubes, once heated the heat will raise the roof up. I connected the s
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in