Thingiverse
Indicator holder 0XA Back side mount
by bissefar
24
Downloads
6
Likes
0
Makes
Indicator holder for QCTP set 3112 from Littlemachineshop.com.
2 vertical 5.1 mm holes for M6 Thread, and 1 horizontal 8.2 mm hole for the indicator.
The 5.1 mm holes needs på to be drilled a bit, and then tapped. The rest fits fine. I made it to measure on the back side of the main spindle.
3D Printed on a GEEEtech i3
2 vertical 5.1 mm holes for M6 Thread, and 1 horizontal 8.2 mm hole for the indicator.
The 5.1 mm holes needs på to be drilled a bit, and then tapped. The rest fits fine. I made it to measure on the back side of the main spindle.
3D Printed on a GEEEtech i3
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in