Thingiverse
CR10 filament guide
by Mathi159
274
Downloads
159
Likes
3
Makes
Remixed bowden drive sensor with arm for a wheel to guide the filament. The high pitched squeaky noise the printer (filament and/or extruder?) emits when moving the filament was resolved with this.
You can use the original filament guide that comes with the CR10S and put this one under it (2mm longer screws would be nice if you have them). Each wheel attachement needs a 608 bearing and an m3x20 + bolt.
Updated with a two wheel version for better alignment.
The wheel was remixed (enlarge
You can use the original filament guide that comes with the CR10S and put this one under it (2mm longer screws would be nice if you have them). Each wheel attachement needs a 608 bearing and an m3x20 + bolt.
Updated with a two wheel version for better alignment.
The wheel was remixed (enlarge
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in