Thingiverse
Snapmaker Fan Duct, Bracket, and Touchscreen Bracket Extension
by ock10
50
Downloads
22
Likes
0
Makes
Duct for 50mm blower fans with a 20mm x 15mm outlet.
Fan Bracket attaches under existing side cover screws.
Blower fan is mounted with fan intake facing out, so that you can tell if it's powered, and so that it's not getting blocked by the front face of the 3d printing module.
Fan was screwed to fan bracket with a Subaru speaker screw, which resembles a 5mm wood screw thread.
The bracket for the touchscreen must be moved left by one screw hole, or moved forward 1 inch with the 3d-p
Fan Bracket attaches under existing side cover screws.
Blower fan is mounted with fan intake facing out, so that you can tell if it's powered, and so that it's not getting blocked by the front face of the 3d printing module.
Fan was screwed to fan bracket with a Subaru speaker screw, which resembles a 5mm wood screw thread.
The bracket for the touchscreen must be moved left by one screw hole, or moved forward 1 inch with the 3d-p
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in