Thingiverse
Anet A6 Y-Belt Holder
by Sisul
47
Downloads
19
Likes
0
Makes
I enjoy designing things, then printing and seeing them working. That's why I decided to design my own Y-belt holder.
My aims were as follows:
- Height compensation, so that the belt runs parallel
- Belt can be mounted without tools
- Easy to mount
- Use of the original screws
The result is available in two versions, the 18mm version for the H-beam above and the 12mm version for the beam below.
I printed my holder relatively slowly and with good resolution because the tooth profile re
My aims were as follows:
- Height compensation, so that the belt runs parallel
- Belt can be mounted without tools
- Easy to mount
- Use of the original screws
The result is available in two versions, the 18mm version for the H-beam above and the 12mm version for the beam below.
I printed my holder relatively slowly and with good resolution because the tooth profile re
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in