Thingiverse
Anycubic Kossel plus damper feet
by Ortovox
20
Downloads
8
Likes
0
Makes
These are my Kossel Plus damper feet based on JamesWhite top covers for the Kossel plus.
I changed original design to use separate screws so that they can be printed solid and the rest with infill 20%. And then of course I changed the design to be able to work as feet.
This was done by adding the triagles on top that goes into the base of the printer to make sure the feet does not move and the cross that attaches the damping rubber feet in the bottom.
The fit for the screws can be very ti
I changed original design to use separate screws so that they can be printed solid and the rest with infill 20%. And then of course I changed the design to be able to work as feet.
This was done by adding the triagles on top that goes into the base of the printer to make sure the feet does not move and the cross that attaches the damping rubber feet in the bottom.
The fit for the screws can be very ti
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in