Thingiverse
A8 inductive sensor mount middle 12mm
by floppyslap
9
Downloads
4
Likes
0
Makes
This sensor mount uses the space between X carriage and X rails. In this way the sensor is as close to the hot end as possible giving very repeatable measurements.
It may collide with your cooling nozzle.
The space will fit 12mm sensor but not 18mm sensor.
Hole diameter in project is set to 12mm, but my printer prints it a bit smaller, so 11.8mm sensor screws very well. You can't use nuts there, no space.
Configuration.h for marlin:
`#define X_PROBE_OFFSET_FROM_EXTRUDER -20`
`#defi
It may collide with your cooling nozzle.
The space will fit 12mm sensor but not 18mm sensor.
Hole diameter in project is set to 12mm, but my printer prints it a bit smaller, so 11.8mm sensor screws very well. You can't use nuts there, no space.
Configuration.h for marlin:
`#define X_PROBE_OFFSET_FROM_EXTRUDER -20`
`#defi
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in