Thingiverse
Fuel Cap Tool
by Dragon2781
5
Downloads
3
Likes
0
Makes
I designed this little tool in Tinkercad.
I use it to open and close the fuel and fresh water caps of our ship.
The 'blade' is printed horizontal so that the layers can resist the shear forces.
I recomment using 'Tough PLA' or ABS for the 'Blade'.
Layer Hight = 0.1mm
Infill of the Blade = 100%
Infill of the Handle = 30%
No Support needed
I use it to open and close the fuel and fresh water caps of our ship.
The 'blade' is printed horizontal so that the layers can resist the shear forces.
I recomment using 'Tough PLA' or ABS for the 'Blade'.
Layer Hight = 0.1mm
Infill of the Blade = 100%
Infill of the Handle = 30%
No Support needed
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in