Thingiverse
Moto G5 Plus magnetic charging dock
19
Downloads
12
Likes
0
Makes
Uses the same charging cable as the remix source, but sized for a Moto g5 **with a soft gel case**.
The fit on the cable wasn't tight enough to prevent it from sliding, once I printed this in PLA instead of PETG, so I also printed a cover to insert underneath to hold the cable in place. You could also glue either that cover or the cable itself and not worry about it.
## TODO:
* Fit on the side could be tighter
* Fit on the cable could be tighter
The fit on the cable wasn't tight enough to prevent it from sliding, once I printed this in PLA instead of PETG, so I also printed a cover to insert underneath to hold the cable in place. You could also glue either that cover or the cable itself and not worry about it.
## TODO:
* Fit on the side could be tighter
* Fit on the cable could be tighter
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in