Thingiverse
Mini antenna Mast
by xJMV
15
Downloads
11
Likes
0
Makes
This mini mast allows multiple antennas to be mounted above the roof level.
I used UV resistant marine grade silicon to seal every joint. I also added silicon just before the final push of the adapter to ensure it will not move up with wind. Prior to install the antenna, I used self-fusing tape from the coax to the top of the connector to ensure maximum water protection.
To install the anchor plate, I use 4x 1/4in lag screws with 1/4in washers.
*** I printed the anchor plate, the mast p
I used UV resistant marine grade silicon to seal every joint. I also added silicon just before the final push of the adapter to ensure it will not move up with wind. Prior to install the antenna, I used self-fusing tape from the coax to the top of the connector to ensure maximum water protection.
To install the anchor plate, I use 4x 1/4in lag screws with 1/4in washers.
*** I printed the anchor plate, the mast p
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in