Thingiverse
Cetus Carrier Handle
by imaicom
21
Downloads
7
Likes
0
Makes
I devised a handle that is convenient to carry.
As an additional specification, I tried to change the handling of the filament tube. I attached a filament guide, but all is unnecessary. It is better not to use the hole built into the handle.
The difficult part to assemble is the embedding of M3 nuts. It is easy to work with using M3's 20 mm long screw.
[Caution] If the stepping motor on the Z axis vibrates after replacement and can not be initialized, do as follows. Please exchange wit
As an additional specification, I tried to change the handling of the filament tube. I attached a filament guide, but all is unnecessary. It is better not to use the hole built into the handle.
The difficult part to assemble is the embedding of M3 nuts. It is easy to work with using M3's 20 mm long screw.
[Caution] If the stepping motor on the Z axis vibrates after replacement and can not be initialized, do as follows. Please exchange wit
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in