Thingiverse
RC Controller Thumb Knobs
by moiam
9
Downloads
6
Likes
0
Makes
I felt my old knobs for my RC controller was small and with bad grip so I made some new ones that utilized a thumb grip instead.
Just glue the top and bottom part against each other with super glue.
The hole for the knob is 3mm and 10mm long. Then there is 3mm deep at the entrance that is 4mm wide in order to slide over the non-threded rod.
The structure can most likelly be drilled to fit larger rods.
Just glue the top and bottom part against each other with super glue.
The hole for the knob is 3mm and 10mm long. Then there is 3mm deep at the entrance that is 4mm wide in order to slide over the non-threded rod.
The structure can most likelly be drilled to fit larger rods.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in