Thingiverse
Lenovo K300 Series 120mm Top Fan Mount
by IDoesStuff
0
Downloads
3
Likes
0
Makes
This will replace the "handle" on top of the Lenovo Thinkcentre K300 series desktops with a 120mm fan.
The graphics card in this K330 was replaced with a gtx 1060 and due to the poor airflow the whole case became warm to the touch and cpu and gpu temps under load were getting too high.
The handle comes off without too much trouble by bending back the plastic tabs inside the case and pulling up on the top layer of the handle. There are a few phillips screws under the top layer that also ne
The graphics card in this K330 was replaced with a gtx 1060 and due to the poor airflow the whole case became warm to the touch and cpu and gpu temps under load were getting too high.
The handle comes off without too much trouble by bending back the plastic tabs inside the case and pulling up on the top layer of the handle. There are a few phillips screws under the top layer that also ne
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in