EMAX Hawk 5 GoPro Session Mount

I used the X220 model as a basis for this one.

Major changes:
- can be screwed on Hawk 5 frame with original screws
- should be fixed with a 2.5mm tie-wrap at the back (see picture)
- NO SUPPORTS FOR PRINTING! (I hate support material on flex objects)

Can be a bit tight to pass the strap to hold the GoPro. Just fold the first part double and then it will be a lot easier. This is because I had to change the angle of the hole so it would print without supports.

Screw holes are pretty t