Ender 3 adaptor for MKS Gen L

This is an adaptor for using a MKS GEN L controller board on an Creality Ender 3.

The MKS GEN L screws to the adaptor using the original Ender 3 controller screws and the adaptor then just pushes on to the original screw mounts.

I had to drill out the small holes with a 2.5mm drill and the large holes with a 5.5mm drill.

As for fitting the MKS GEN L to an Ender 3 I had to extend the two cables for both thermistors and I had to change the end stop connectors from 2pin JST connectors to 3