Thingiverse
Wake Shaper
by mpyr6
71
Downloads
64
Likes
1
Makes
This wake shaper was designed to be 3D printed and requires minimal hardware to be built. Using two suction cups to mount, there is no damage to the hull and can be switched from port to starboard in moments.
8/20/18 Update: Lost the shaper in the water this weekend. When printing make sure that the Body Back is printed sitting flat otherwise there is a 100% chance that the rear security loop will break. Working on a rev. 2 to combat this issue. In the meantime be aware of the curvature of th
8/20/18 Update: Lost the shaper in the water this weekend. When printing make sure that the Body Back is printed sitting flat otherwise there is a 100% chance that the rear security loop will break. Working on a rev. 2 to combat this issue. In the meantime be aware of the curvature of th
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in