Thingiverse
IKEA Ivar Cabinet Key
by churusaa
10
Downloads
9
Likes
0
Makes
Replacement key for IKEA Lack Cabinet/locker, since they each only come with one.
Should probably be printed at 0.15 with supports. Tolerances shouldn't be all that tight, but there doesn't appear to be an orientation for it that wouldn't require supports. I might scratch up a revision that requires fewer/no supports, but this is a first attempt.
V1 matches the measurements I took from my original key, but I couldn't get it to fit. This was likely because my slicing software scaled it to 9
Should probably be printed at 0.15 with supports. Tolerances shouldn't be all that tight, but there doesn't appear to be an orientation for it that wouldn't require supports. I might scratch up a revision that requires fewer/no supports, but this is a first attempt.
V1 matches the measurements I took from my original key, but I couldn't get it to fit. This was likely because my slicing software scaled it to 9
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in