Thingiverse
BLTouch Mount for FLSun QQ
by Av8er
103
Downloads
65
Likes
0
Makes
BLTouch Mount for FLSun QQ Delta printer.
You will need 3 M3x10 screws to assemble and 2 screws from the BLTouch kit (or 2 M3x5) to mount.
Run a M3 tap through the holes in the top plate and the two holes in the bottom piece. If you dont have a tap slowly work the M3 screws in and out of the parts to cut the threads.
To mount to the effector unscrew the single M3 screw from the bottom under the logo side. Snap the mount on and use a M3x10 screw to secure. The tabs of the bltouch go on
You will need 3 M3x10 screws to assemble and 2 screws from the BLTouch kit (or 2 M3x5) to mount.
Run a M3 tap through the holes in the top plate and the two holes in the bottom piece. If you dont have a tap slowly work the M3 screws in and out of the parts to cut the threads.
To mount to the effector unscrew the single M3 screw from the bottom under the logo side. Snap the mount on and use a M3x10 screw to secure. The tabs of the bltouch go on
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in