Thingiverse
Piper 1 Heavy Duty Customisable Modular E3D V6 Mount
by Zinoberrot
13
Downloads
5
Likes
2
Makes
This is a simple remix of Chito's modular mount design to fit on the Piper 1 3D printer.
It is intentionally a little bit low, that will steal a few mm's of Z travel but allows for the insertion/removal of the fan's frame support nuts without having to disassemble the whole gantry.
All of Chito's mounts/wings fit fine, allowing you to pair your E3D hotend (or a clone) with BL Touch / ABL / Inductive / Capacitive auto-leveling sensors, 5015 fan(s), etc. Check out Chito's designs over here:
It is intentionally a little bit low, that will steal a few mm's of Z travel but allows for the insertion/removal of the fan's frame support nuts without having to disassemble the whole gantry.
All of Chito's mounts/wings fit fine, allowing you to pair your E3D hotend (or a clone) with BL Touch / ABL / Inductive / Capacitive auto-leveling sensors, 5015 fan(s), etc. Check out Chito's designs over here:
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in