Thingiverse
FT Explorer Printed Motor Pod
74
Downloads
40
Likes
0
Makes
UPDATE: 08/10/2020 - Designed in inches.
UPDATE: 08/19/2018 - uploaded a corrected stl, Firewall Mount Plate.stl file, slots for mounting motor were off slightly.
Units: inches
Print each half flat side on bed of printer.
Note orientation of motor mount plate (half circle to the top).
Position of Mount Plate is dependent on whether you are running the "B" or "C" pack from Flite Test.
Assemble then glue together with CA glue.
I assemble the unit and tape it with masking tape then glue.
UPDATE: 08/19/2018 - uploaded a corrected stl, Firewall Mount Plate.stl file, slots for mounting motor were off slightly.
Units: inches
Print each half flat side on bed of printer.
Note orientation of motor mount plate (half circle to the top).
Position of Mount Plate is dependent on whether you are running the "B" or "C" pack from Flite Test.
Assemble then glue together with CA glue.
I assemble the unit and tape it with masking tape then glue.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in