Thingiverse
CR 10 - bobine support
by Squall290586
1
Downloads
0
Likes
0
Makes
It's a bobine support for a CR-10.
This support allow to install the bobine on the left-top of the printer.
In order to have the lowest friction, i install 2 bearing (20X47X14 mm).
The installation is make with two M4 screw with a T nut.
The spacer are make in order to install a "dailyfil" bobine.
If you want install an other brand, you must create your spacer :).
This support allow to install the bobine on the left-top of the printer.
In order to have the lowest friction, i install 2 bearing (20X47X14 mm).
The installation is make with two M4 screw with a T nut.
The spacer are make in order to install a "dailyfil" bobine.
If you want install an other brand, you must create your spacer :).
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in