Thingiverse
1x4x4
by kequals
87
Downloads
60
Likes
1
Makes
A non-pillowed 1x4x4 (floppy revenge) twisty puzzle. This puzzle can make 180 degree turns.
To make, print each part by the number indicated on the filename.
* 4 Corner
* 8 Edge
* 3 Center 1
* 1 Center 2
* 1 Pin
The screw I used was M3 x 4mm. I first found a small M3 screw, then manually ground it down until it was 4mm long. Make sure that your screw is still threaded. The screw needs to be extremely small for the puzzle to work, while still having enough threads to not fall out. The
To make, print each part by the number indicated on the filename.
* 4 Corner
* 8 Edge
* 3 Center 1
* 1 Center 2
* 1 Pin
The screw I used was M3 x 4mm. I first found a small M3 screw, then manually ground it down until it was 4mm long. Make sure that your screw is still threaded. The screw needs to be extremely small for the puzzle to work, while still having enough threads to not fall out. The
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in