Bokken Scabbard

This is a scabbard/sheath for a bokken (https://tinyurl.com/y8szv4uk) training sword and is optimized for swords 40'' and under.

This project requires:

-Sheath Mk1 (for the full scabbard 2 of these pieces are needed)
-Sheath Mk2
-Sheath Mk3
- Krazy Glue https://tinyurl.com/yaocwg49 (or Soldering Iron or both)
-Sandpaper https://tinyurl.com/yd9cu2x9 (Optional)
-Wood Stain https://tinyurl.com/y9u6hl7h (Optional, but only applicable if you use wood PLA)
- Wood/Metal Finish (Optional, but only applicable if you use wood PLA)

Construction of full sheath/scabbard:

-Print out two of Sheath Mk1
-Print out Sheath Mk2 and Mk3
-Slide the pieces on the bokken (from bottom to top) in the order Mk1, Mk2, Mk1 (the second one), Mk3 (on top). Make sure the printed piece aligns with the curves and edges of the sword.
-Use Krazy Glue and/or a Soldering Iron to secure the pieces together DO NOT GLUE THE SWORD TO THE SCABBARD
-[OPTIONAL] If you have sandpaper, sand down the scabba