Thingiverse
Arduino RAMPS 1.4 Prusa Support with fan
by autronix
9
Downloads
17
Likes
0
Makes
This is a support for RAMPS 1.4 and arduino on a Mendel Prusa.
It locates the whole electronics on the upper section of the printer.
It also features the possibility to add a 90mm fan to cool down the stepper drivers as well as a central filament guide.
The original model was printed in ABS with a 0.20mm layer height. Takes about 3h30 to print.
NOTE: The support for the fan has to be treated gently. I will reinforce the columns in a future revision.
It locates the whole electronics on the upper section of the printer.
It also features the possibility to add a 90mm fan to cool down the stepper drivers as well as a central filament guide.
The original model was printed in ABS with a 0.20mm layer height. Takes about 3h30 to print.
NOTE: The support for the fan has to be treated gently. I will reinforce the columns in a future revision.
Sign in to leave a comment
Sign in