Thingiverse
CR-10S stock Filament Runout Detection switch holder & cleaner
39
Downloads
33
Likes
0
Makes
the name pretty much sums it up.
uses the 3 existing screws from the run out housing that comes with your cr-10s.
may need drilling a little where the filament guide is to fit the 4mm Bowden Tube perfectly and slide filament with ease.
I used sound proofing foam for the cleaner. you can use any dust free foam you see fit tho.
secures cable with a zip tie.
attaches to the same z-rod screws as the original ((DO NOT OVER TIGHTEN))
((DO NOT SUPER GLUE THE DETECTION SWITCH HOLDER
uses the 3 existing screws from the run out housing that comes with your cr-10s.
may need drilling a little where the filament guide is to fit the 4mm Bowden Tube perfectly and slide filament with ease.
I used sound proofing foam for the cleaner. you can use any dust free foam you see fit tho.
secures cable with a zip tie.
attaches to the same z-rod screws as the original ((DO NOT OVER TIGHTEN))
((DO NOT SUPER GLUE THE DETECTION SWITCH HOLDER
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in