Delta Rod Jig

Another Delta Rod Jig. This one is for use with Traxxas 5347 with the hollow ball installed in the rod end. Use a M3 x 15 screw in the jig. Depending on your printer you might need to run a 3mm drill through the center hole. Don't ream the hole out too much as you want the bolt to stay tight in the hole.

Measurement from the c/l of the screw to the edge of the jig is 7mm

Measurement from the c/l of the screw to the c/l of the mounting hole is 11mm

Measurement from the c/l of the screw t