Thingiverse
Octopi touch 3.5 Raspi case + CR10 mount
by BePrint
107
Downloads
48
Likes
0
Makes
To use my Raspberry Pi3B+ with Octopi on my Ender 3 I make a Case where the 3,5'' LCD-Touchscreen is stable integreated.
This case could be used universal, at the bottom there are 4 holes to mount.
To mount it to my Ender 3 I make this special mount.
UPDATE 2018-10-23:
When I decided to connect a relay board to my Raspberry, I realized that I had to set the touchscreen higher.
I connected the touchscreen to the Raspberry with a pin header so I had enough space to connect the relay boa
This case could be used universal, at the bottom there are 4 holes to mount.
To mount it to my Ender 3 I make this special mount.
UPDATE 2018-10-23:
When I decided to connect a relay board to my Raspberry, I realized that I had to set the touchscreen higher.
I connected the touchscreen to the Raspberry with a pin header so I had enough space to connect the relay boa
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in