Thingiverse
PowerSpec Ultra 2.0 Spool holder
by redwingsmike
21
Downloads
17
Likes
2
Makes
A simple snap together (with a little help from a hammer) spool holder for the PowerSpec Ultra 2.0 printer.
The original holders only work with spools that have large enough openings to fit over the bump ends of the holders, none of mine did so loading the right extruder counter clockwise was not possible without it falling off while printing. I also have some spools with only a 55mm opening on either end so this solves both issues.
As always, I searched thingiverse first before making th
The original holders only work with spools that have large enough openings to fit over the bump ends of the holders, none of mine did so loading the right extruder counter clockwise was not possible without it falling off while printing. I also have some spools with only a 55mm opening on either end so this solves both issues.
As always, I searched thingiverse first before making th
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in