Thingiverse
Anet A8 Motherboard Fan Holder 80mm
by mrando001
0
Downloads
0
Likes
0
Makes
I looked after a cooling method for the motherboard but I didn`t find one that I liked. So I made my own :)
The benefits of this holder are:
- qucik and cheap print
- very quick installing. You just put the holder under the frame right under the motherboard
- no screws needed: the fan is hold by physics
- the 45 degrees position is in my opinion a good strategy for blowing air on the motherboard. Especially the bottom, where the hottest parts are.
- you can reach the SD slot, U
The benefits of this holder are:
- qucik and cheap print
- very quick installing. You just put the holder under the frame right under the motherboard
- no screws needed: the fan is hold by physics
- the 45 degrees position is in my opinion a good strategy for blowing air on the motherboard. Especially the bottom, where the hottest parts are.
- you can reach the SD slot, U
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in