Thingiverse
Ribbon Candy
by NAK3DDesigns
38
Downloads
47
Likes
0
Makes
Here are two versions of my design to print Ribbon candy (not for consumption)...
This is designed to be printed in Vase Mode with zero top/bottom layers and then cut into two seperate pieces.
Samples were printed with Polyalchemy filaments in vase mode with a 1.2mm nozzle and .4 layer height at 25mm/sec, but I'm sure could be printed at any size.
I did leave some space between ribbons for ease of printing. The space can easily be closed by heating with a hair drier.
This is designed to be printed in Vase Mode with zero top/bottom layers and then cut into two seperate pieces.
Samples were printed with Polyalchemy filaments in vase mode with a 1.2mm nozzle and .4 layer height at 25mm/sec, but I'm sure could be printed at any size.
I did leave some space between ribbons for ease of printing. The space can easily be closed by heating with a hair drier.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in