Thingiverse
Archery Target Face Pin
von JayLuvLL
117
Downloads
69
Likes
1
Makes
This is an archery target face pin, that is deisgned to hold up paper target faces when using a foam or similar material as a backstop.
Prints without supports. Would recommend at least 2-3 shells and at least 20% infill.
Prints without supports. Would recommend at least 2-3 shells and at least 20% infill.
Makes
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
Anmelden