Thingiverse
Ikea Skådis - holder for foldable ruler
by josteinaj
168
Downloads
100
Likes
1
Makes
A holder for a 2m ruler that can be attached to a Ikea Skådis pegboard. The inner dimensions fit my ruler, and are:
- 32mm long
- 17mm wide
Measure your ruler before printing this, I'm not sure if this fits most 2m foldable rulers or not.
The design is so that there are no angles steeper than 45 degrees if you print it upside down, and so no supports should be needed for this one.
- 32mm long
- 17mm wide
Measure your ruler before printing this, I'm not sure if this fits most 2m foldable rulers or not.
The design is so that there are no angles steeper than 45 degrees if you print it upside down, and so no supports should be needed for this one.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in