Thingiverse
Cable Clips for ZD-917 Desoldering Station
by hotkey
12
Downloads
13
Likes
0
Makes
The hoses of the ZD-917 desoldering station get tangled up very easily.
These small clips can be lasercut (or printed) and snapped between the suction hose and the electrical cable to keep them parallel and prevent them from getting tangled up.
Just lasercut a bunch of them out of acrylic (3mm works fine, wood might also do the job) and clip them on. The air hose is easy, but use your fingernail on the electrical cable's insulation to gently push it into the clip. Should be a nice, snug fi
These small clips can be lasercut (or printed) and snapped between the suction hose and the electrical cable to keep them parallel and prevent them from getting tangled up.
Just lasercut a bunch of them out of acrylic (3mm works fine, wood might also do the job) and clip them on. The air hose is easy, but use your fingernail on the electrical cable's insulation to gently push it into the clip. Should be a nice, snug fi
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in