Thingiverse
Extruder holder for Geeetech i3
by martinyazz
21
Downloads
18
Likes
0
Makes
This is a holder to fit a Geeetech i3 pro b or similar.
It is for a Bowden type setup and fits an E3D V6 Extruder.
The mount replaces the projecting extruder holder as fitted to the Geeetech i3 pro B setup which is a direct extruder setup with motor etc. The mount is designed to fit straight onto the X carriage plate and bolt through into the bearing holders. You may need slightly longer screws (8off 12mm or 15mm x 3mm) to replace the supplied ones and also 2 x 60mm screws to bolt the main c
It is for a Bowden type setup and fits an E3D V6 Extruder.
The mount replaces the projecting extruder holder as fitted to the Geeetech i3 pro B setup which is a direct extruder setup with motor etc. The mount is designed to fit straight onto the X carriage plate and bolt through into the bearing holders. You may need slightly longer screws (8off 12mm or 15mm x 3mm) to replace the supplied ones and also 2 x 60mm screws to bolt the main c
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in