Thingiverse
Pi zero w snap case lid with 3 cherry mx switch slots.
by bungwu
12
Downloads
8
Likes
0
Makes
Snap case lid with 3 cherry mx switch slots.
I was getting sick of running to my PC to cancel prints when the first layer messed up. I had already printed the snap case (https://www.thingiverse.com/thing:1167846) , so I designed a lid to house 3 cherry mx switches that can control octoprint.
It is very simple to wire up cherry mx switches to a pi zero w. Just solder 1 pin of each switch to a shared ground wire and then the remaining switch pins go to their own gpio pin, no need for diod
I was getting sick of running to my PC to cancel prints when the first layer messed up. I had already printed the snap case (https://www.thingiverse.com/thing:1167846) , so I designed a lid to house 3 cherry mx switches that can control octoprint.
It is very simple to wire up cherry mx switches to a pi zero w. Just solder 1 pin of each switch to a shared ground wire and then the remaining switch pins go to their own gpio pin, no need for diod
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in